WEBVTT

prepare
00:00:00.300 --> 00:00:05.500
At 0 seconds, turn Auto Blur off.

draw
00:00:05.500 --> 00:00:11.000
Choose Rectangle under Manual Blur and draw around the entire face.

range
00:00:11.000 --> 00:00:15.000
Confirm that the blurred rectangle covers the 0–8 second interval.

start-track
00:00:15.000 --> 00:00:18.000
Choose Start tracking and wait for the calculation.

tracked
00:00:18.000 --> 00:00:24.000
When Tracking calculated appears, inspect the actual face coverage.

middle
00:00:24.000 --> 00:00:32.000
Move the playhead to 4 seconds and compare the face with the rectangle.

margin
00:00:32.000 --> 00:00:38.000
Drag a corner handle slightly outward to leave more room around the jaw.

scope-notice
00:00:38.000 --> 00:00:42.000
The notice says this adjustment was also applied across the surrounding
8-second interval.

this-frame
00:00:42.000 --> 00:00:46.000
For this correction, choose This frame only.

keyframe
00:00:46.000 --> 00:00:53.000
Check the keyframe at 4 seconds and the calculation status.

no-op
00:00:54.500 --> 00:01:01.500
The second Start tracking click found no gap to fill, so it did not run
another calculation.

last-frame
00:01:02.000 --> 00:01:07.000
Go to the final frame and check that the face is inside the rectangle.

check-edges
00:01:07.000 --> 00:01:13.600
If an edge is exposed, adjust that point and review the surrounding interval
again.

full-playback
00:01:13.600 --> 00:01:23.200
Play all 8 seconds from the beginning and watch the face edges throughout.

finish
00:01:23.200 --> 00:01:29.000
Finish your review by checking both individual frames and the full playback.